Cant tell what the actual serial number is with that 1. If I use the 143931 number it was made in 1916. If I go by the 43931 serial number it was made in 1904. You are the proud papa of a bouncing baby Trenton. Trenton Anvil Serial Number. Appears to be a three piece construction.With penciled in production serial numbers, weights and year made.Thanks for reply. Trenton anvils were made from 1898 to 1952. Elizabeth Svecova on Trenton Anvil Serial Numbers yondar.
Trenton Anvil S Serial Number IsFlour and look harder for a serial number. Thanks for suggesting Belknap as a search for that lead to me finding the iforgeiron page.Need help identifying this Trenton anvil. From a post on iforgeiron I just found, this would put the lettering in about the right spot for it to be a Bullock hardware store stamp. After flour dusting the logo again I can just barely make out an OC above the Chicago. There are no numbers or letters on it. Subscribe Subscribed Unsubscribe 28 28. 95lb TRENTON Anvil Ironsmyter. Old industrial site way too much iron in. Convert text to for macIt is around 3/16" on both sides. Do you think it would hurt the value of the anvil if I would clean up the mushroomed sides of the cutting shelf? Just the overhanging steel that has been squished out past the original shelf. It is mushroomed out on both sides. It has 2 grooves on both sides where it looks like they bent rod around it. ![]() Postman says that a higher percentage of Arm and Hammer anvils he has seen were in far better condition than any other make of anvil he has seen. Arm and Hammer bought some of the same cast steel bases that Trenton used. (Trenton) They were neighbors and even had some forgings done at each others shops. Was actually started by a former employee and anvil maker for Columbus Forge and Iron Co. Columbus Anvil and Forging Co. Your serial number 38508 would put the production year within 1922-1923 Arm and Hammer anvils share many of the same shapes and qualities of Trenton anvils. Also an old style Peter Wright classic about 150 lbs, clean, flat table. I have a 226 lb Hay Budden (small chips along the edges but a good table, could be easily dressed with a belt sander, a nice classic for a shop center of attraction).
0 Comments
Leave a Reply. |
AuthorLisa ArchivesCategories |